First Powerlifting Meet Experience

On Saturday, April 16, I made my powerlifting debut as both a competitor and a coach.  My team and I competed in the Revolution Powerlifting Syndicate 18th Annual PowerPalooza that took place in Lancaster, Pennsylvania.

RPS Revolution Image

Competition

The official start to the competition was the explanation of the rules for the event. This allowed any gray areas to be cleared up and questions to be asked.  With a basic understanding of the rules coming into the meet this definitely gave me a better understanding of how the meet would flow through the day and the specifics for each lift (timing, technique specifics, commands).

After the rules meeting, the nerves and anxiety increased as the morning session of female and lower weight class male competitors wrapped up their awards ceremony.  Once the flights for the afternoon session were posted, I found that I was in the first of three flights for each event. With two of my athletes in the second flight, and one in the third, my team was represented in each flight and helped spread our lifts throughout the day.  With my first lift approaching, I began to warm up in the designated area which included two monolifts, two benches, and two deadlift platforms.

Squat

I found two adjustments for squat that I needed to make right away in warm ups.  The first adjustment was using the monolift.  I have seen these in gyms in the past but have never test driven one.  A monolift is a specialized squat rack where once the bar is lifted off of the hooks, the hooks are moved out of the way so that the lifter does not need to step out from the hooks with a large load on the spine.  During the rules meeting one of the helpful tips given was for lifters who had never used a monolift, don’t start now.  This meant for the competition to step out from the hooks just like I would a normal squat rack.  Coming in to the meet I wasn’t sure if I would step out or not, but this made sense and helped to solidify my approach.  The second adjustment was the barbell used for competition. It was a 65-pound barbell that was thicker and had a sharper knurling than the barbells that I have been training with.  I have used a thicker than traditional barbell in training so this was not as much of an adjustment; the main adjustment for me was planning my weights for warm ups as plates were added.  This may not seem like a big deal as it is just simple math, but my mind raced as the opening lifts approached and this became more difficult than it should have been.

After making adjustments, my warm ups went well and I hit the weights that I wanted.  I felt really good and hit my opening attempt weight, 285, with my last warm up rep about ten minutes before my flight started.  I was around 7th or 8th in the flight order so the next twenty minutes involved a good amount of pacing and jittery foot tapping as I anxiously awaited my first attempt on stage.  Finally (it seemed like a much longer wait than it actually was), I was up and went out for my first attempt.   It certainly was a different feeling being out on the stage under the lights, but I completed my squat with a little concern about my depth.  But the three green lights after I racked the weight eased that concern and forced me to think about my next attempt.  I decided to go with 305 which was my 1-rep max coming in to the competition.  As the rest of the flight continued on I loosened up my shoes and tried to ease some of the tension I was putting on myself.  With the first attempt completed, I was definitely much more relaxed going in to my second attempt. My second attempt of 305 went very smoothly and I decided to take a bigger jump than I expected coming in to the meet and went for 320 on my third attempt.  On my third attempt I felt really good about the attempt as soon as I unracked the weight as it didn’t feel as heavy on my back as I expected it would.  I hit my depth, hit a little bit of a grind out of the bottom but was able to complete the lift.  A great start to the meet as I went three-for-three on attempts and knew that I would be leaving the meet with a minimum of a 15-pound personal record in squat.

Brian Squat

This energy continued onto my athletes as each of them hit all three of their attempts in squat and each of them set new personal bests in the process.   Each of their personal bests was at least 10 pounds better than their previous maxes.  My two lifters in the 198 weight class both squatted 415, and my third lifter in 220 pound weight class squatted 460. Not bad at all for two high school seniors and one college freshman.   A great start for our team after one event!

 

Bench Press

Next up was the bench press in which I started to warm up in between my third lifter’s squat attempts.  Warm ups went smoothly, though I began to notice my first mistake of the meet. After I finished squatting, I talked with my athletes and family and paced around the facility through all three flights. Because I did this and didn’t sit down for any extended times I noticed that my low back began to tighten up.  Though it didn’t affect my performance, it was annoying.  As I warmed up for bench I went over my opener of 185 and hit 190 for a single. I wasn’t nervous about 185 as I’ve hit it in training plenty of times so I wanted the increased weight to give me confidence in the second and third attempt.  The 185 went as planned and my second attempt was set for 205 (previous max coming into the meet).  The 205 went smoothly so in feeling pretty good, I decided to jump to 220 for my third attempt.  This was a bit too big of a jump as I lifted about two inches off my chest and hit a wall.  While it didn’t end up in a new record, I’m glad that 205 felt as good as it did and will look for 215 in a couple weeks.

Once again my athletes each achieved new personal bests.  With one of them completing all three attempts and the other two completing two out of three, it was a strong showing by our team. Of my two 198 class competitors, one lifted 210 while the other hit 290. My 220 weight class competitor finished at 300.

Deadlift

Wrapping up the day was deadlift.  Once again I was in the first flight and began to warm up towards the midway point of the third attempts of the last flight of bench press.  This turned out to be a little too early. Realizing this I cut my warm up at 225, killed some time, and came back and moved through the second part of my warm up with 225, 275, 315 and 335. With my opener being 325, I warmed up with 335 because I was feeling really good as my low back began to loosen up (very surprised that this happened with deadlift of all movements).  My first attempt of 325 on stage went well and decided to make the jump to 355 which also went smoothly although my set up was off. As I lowered to the bar, I realized that I forgot to take my big inhale at the top so I stopped midway, reset, and continued with the lift.  I think this was because I never settled into a consistent deadlift set up routine during training. My set up changed as the weights changed, so this is something that I need to work on moving forward.   My last attempt was 375.  This weight was my goal for coming in to the meet because a month earlier in training I failed on this weight around the knee.  Today I completed the rep and felt decently fast through the rep.

My athletes completed all of their deadlift attempts and put up some big personal records in the process.  My two 198 competitors finished with 430 and 435-pound deadlifts while my 220 class lifter completed a 500 pound deadlift without using a belt! Great work all around!

 

Overall

Looking at all three lifts I completed a 900-pound total. Coming in to the meet I hoped to crack 900 and I was able to do just enough.  I was very pleased with squat and deadlift. With bench press, I did about what I expected.  I had hoped to break my previous record but realize that my training was focused more on squat and deadlift.

As far as competition, my main focus was myself.  I didn’t watch other competitor’s in my classes totals closely because I was too busy trying to plan my teammates and my first meet.  My 900-pound total was good enough for third place in my division- 181 Open Raw Classic.  This meant that I was able to take home this awesome trophy.Brian Third Place Trophy

 

On a whole as a team, I’m very proud of our effort. While it still has not yet been released how are team ranked compared to the other teams competing, I am excited about the personal records that were set and the fact that between the four of us only three attempts were missed.  Individually they finished with two first place and one second place finish in their respective divisions.

 

Experience Outside of Competition

This meet was a blast! It was a great first experience in the sport of powerlifting.  It was very organized and the events moved in a timely fashion.  While I haven’t experienced meets through other organizations, I would have to think that Revolution Powerlifting Syndicate runs their meets as well as the best.  The staff was very approachable and willing to help with any questions that we had.

The one thing that stuck out the most to me on the day was the atmosphere.  While it was a competition, everyone was very supportive of each other.  Through help with loading weights in warm ups, spotting, advice, or motivation each participant was willing to be there for the rest.  It really showed that the sport is more of a brotherhood compared to the team sports I have played in the past.

Even if you don’t think you’re the strongest at your weight in your town I recommend participating in a powerlifting competition simply for the experience.  It provides a target to train for, allows you to meet others with a passion in lifting/training, and can just give you a glimpse at the possibilities of human performance.

 

Leave a Reply

Your email address will not be published. Required fields are marked *